* One-step Hair Plantation

Implanter with Needle		Disposable Needle for Implanter		GraftCyte
Cutting Board		Forcep		Hair Diagnosis Camera system
Hair Counter		Cooler		Pron-pillow

* A distinctive mark

Needle Exchangeble
- A disposable needle can be easily exchanged with hands.
- It is no need an instrument as a screw driver to exchange a needle and also you can also exchange it during the operation.

Different Size
- There is 5 kinds of needle size
- You can create a natural hair shape and volume using different size of needles in the area of donor areas like frontal hair line, middle part of scalp hair, eyelash, eyebrow and pubic area.
Enable to successfully dense pack grafts and performing ‘MEGASESSIONS” of 3,000+ grafts in a one session.

Thin Wall
- Grafts can be snugly fitted in the recipient area with specially manufactured thin needle.
- Only the needle of the thin thickness can make the size of recipient site into the same size of grafts.

Smallest Slit
- The slit width of the needle is so narrow.
- This is for avoiding pulling the grafts out from the needle and recipient area after transplantation.

Cut Edge at 3 angles.
- The front part of the needle edge is cut at single angle unlike most injection needles. - Additionally, we cut the back part of the needle edge twice at the left and right side. - This makes graft to be transplanted with a low angle especially at the temple or eyebrow area and - also would prevent graft damage when the operator place graft onto the needle. - When you place graft onto the general needles with 2 angles only at the front part of the needle, you will find the g In case - Allow for excellent angulation for a natural “ SHINGLING” of hair - Minimize vascular embarrassment, the scar and popping problems etc. - Eliminate the risk of depositioning epidermal tissue under the skin, as can occur with standard round hypodermic needle.

The Rod
- The rod is installed scientifically into the body of hair transplanter.
- This is for pushing a graft with a equal power and avoiding a graft damage
- when the operator placing a graft onto the recipient site.

Adjusting the needle length
- According to the scalp condition and length of hair bulb,
- you can adjust the needle length in a simple way as turning to the left or right side of the hair transplanter’s cap.
- Watching the Video How to adjust the needle length

A design for Human body
- To minimize a weariness of operator,
- the case which the operator will catch is sunken for the purpose that the operator can hold a hair transplanter
- easily during the long surgery time.

Anti-Popping Hole
- In order to avoid the pulling the grafted hair out and planting the grafts more easily,
- there is a anti-popping hole on the back side of needle edge. This is for minimizing the pressure occurring to the skin.

* Product by size

CODE NO	ITEMS	OUT DIAMETER	CODE NO	ITEMS	OUT DIAMETER
FUT001	OSI-06	0.6mm	FUT007	OSI-N-06	0.6mm
FUT002	OSI-08	0.8mm	FUT007	OSI-N-08	0.8mm
FUT003	OSI-10	1.0mm	FUT008	OSI-N-10	1.0mm
FUT004	OSI-13	1.3mm	FUT009	OSI-N-13	1.3mm
FUT005	OSI-15	1.5mm	FUT010	OSI-N-15	1.5mm

OSI-06
- This is the smallest size of needle among our models.
- The out diameter of this needle is 0.6mm(24 Gauge)
- For eyelash and eyebrow surgery and Fine Single Hair
- Color coding ; One Green point on the Cap and Needle

OSI-08
- This is the 2th small size of needle among our models.
- The out diameter of this needle is 0.8mm(22 Gauge)
- For Single Hair as Hair Line of scalp hair, temple area and Pubic Hairs
- Color coding ; One pink point on the Cap and Needle

OSI-10
- The out diameter of this needle is 1.0mm(20 Gauge)
- For 2 Hairs and Middle part of scalp hair
- Color coding ; Two blue points on the Cap and Needle

OSI-13
- The out diameter of this needle is 1.3mm(18 Gauge)
- For 3 Hairs and Middle part of scalp hair
- Color coding ; Three violet points on the Cap and Needle

OSI-15
- The out diameter of this needle is 1.5mm(16 Gauge)
- For 4-5 Hairs and Middle part of scalp hair and Megasession
- Color coding ; Four yellow points on the Cap and Needle


* How To use

How can I adjust a needle length?
Firstly please hold a middle part of the hair transplanter with left or right hand,
and take a cap of hair transplanter with the other hand and then turn the cap away from you to the left or right way.
When you turn the cap to the right way, the needle length will become longer.
When you turn the cap to left way, the needle length will become shorter.

What is suitable needle’s length?
It is different according to the scalp condition and the size of hair bulbs by the individual patient.
Generally the needle’s length is an extent of 7mm.

How to exchange a needle?
Firstly please turn the skin guard(a) away to the left way until it falls apart from the body,
and turn the following (b) like the above method and then turn the needle to the left way untill it falls apart from the body.
Now you can pull out the needle and replace it with same size(or color) of needle.

How can I place a graft onto the needle?
Firstly put the 3-4 grafts on the back of the hand. In order to avoid a dry-up effect,
please often soak grafts into the saline liquids.
Secondly the other hand holding a forceps picks grafts up.
You place a graft on the point where the bevel and slit meet, the hair shaft is toward a downside direction,
the hair bulb is toward a upside direction.
When you pick the grafts, don’t touch a hair bulb but should take a hair shaft off by a 2-3mm from hair bulb.
This is for avoiding damage for follicular units

How to keep the One-Step Implanter after using it?
In Principle you have to break the used needle off in order to prevent the infection problems out of re-using it.
The body of hair transplanter, you keep it at the low temperature condition after clean it by using ultra sonic cleanser.
After drying it fully over 1 hours, you will replace a new needle into the body. The sterilization is highly recommended by using E-O GAS Sterilization.
Unavoidably when you sterilize it using a AUTOCLAVE machine, you should sterilize it with a 123℃ temperature more or less than 15minutes.

Which way of the needle’s Bevel position is recommended?
Generally, the bevel position is toward upside direction during the implanting.
But the back side needle edge is also cut as we mentioned above, you can use it also to the downside direction.

How many times do I insert this needle in one session?
It depends on the patient’s scalp condition.
In case that the scalp is too hard and thin, the needle edge is easy to touch at the bone of head.
Under this condition, the needle edge is a little more to be blunt compare with the normal scalp condition.
Generally in case of the patient with a normal scalp condition you can insert the needle over 200-300 times with original status.

How long do I continue to use the body?
The body can be used around 2 years on condition that you will clean with Ultra sonic cleanser after operation
and sterilize it by GAS sterillization.
But when you sterilize it by AUTOCLAVE, The usage term might be decreased.


* How to exchange the needle


Firstly please turn the skin guard (a) away to the left way until it falls apart from the body,
and turn the following (b) like the above method and then turn the needle to the left way untill it falls apart from the body.
Now you can pull out the needle and replace it with same size(or color) of needle.




* How to adjust the needle’s length


Firstly please hold a middle part of the hair transplanter with left or right hand, and take a cap of hair transplanter with the other hand and then turn the cap away from you to the left or right direction.
When you turn the cap to the right way, the needle length will become longer.
when you turn the cap to left side, the needle length will become shorter.